XTM Racing Rage, Руководство по эксплуатации, Страница: 8 / 20

Page
q
Plug the battery connector on the ESC into the battery connector on the
battery.
+
As a safety feature, the connectors can only be plugged in one way.
q
Double-check that both the transmitter throttle trim dial and the steering trim
dial are centred. Note: The raised tab on the trim dial should be positioned
so that it lines up close to the similiar raised tab to the left of the dial.
o
Slide the transmitter's power switch forward to turn the transmitter 'ON'. All
three transmitter LEDs should light up.
iMpoRtant If the LEDs do not light up check the polarity of the batteries.
If only the red or amber LED lights up, replace the batteries or recharge
them (if using rechargeable NiCD or NiMH batteries).
o
Slide the receiver's power switch to the 'ON' position to turn the receiver
'ON'.
iMpoRtant Lift the Rage 1/18th 4WD Electric Off Road Truck off the
ground before turning on the receiver to ensure that if the motor turns on
when you turn 'ON' the receiver, the Rage 1/18th 4WD Electric Off Road
Truck won't drive away.
iMpoRtant If you turn on the receiver and the motor turns on, turn the throttle trim dial on the transmitter right or left until the
motor stops. This procedure is covered in more detail in the 2CAM's dedicated instruction manual (included).
q
Place the Rage 1/18th 4WD Electric Off Road Truck on the
ground.
o
Rotate the transmitter's steering wheel forward (to the right). The
front wheels should turn right.
iMpoRtant If the wheels don't turn right, flip the steering servo
reversing switch on the transmitter to change the direction that the
front wheels turn.
iMpoRtant Before driving your Rage 1/18th 4WD Electric Off Road Truck,
always turn 'ON' the transmitter first, followed by the receiver. After you're
done driving your Rage 1/18th 4WD Electric Off Road Truck, turn 'OFF' the
receiver first, then turn 'OFF' the transmitter. This will prevent the possibility
of radio interference.