XTM Racing Rage 1/18th 4wd, Руководство по эксплуатации

Страница: 5 / 20

Page
youR Rage 1/18th 4wd electric off Road truck should include the following iteMs sepaRately in the boX:
pRepaRing to dRiVe youR Rage 1/18th 4wd electRic off Road tRuck
Now that you're familiar with the major component parts of your Rage 1/18th 4WD Electric Off Road Truck, and with the functions of the
Cirrus 2CAM transmitter, it's time to prepare your Rage 1/18th 4WD Electric Off Road Truck for its first run.
iMpoRtant Before continuing, please double-check that you've read and understood the warnings on page 2. It's important that you
understand this information before preparing to run your Rage 1/18th 4WD Electric Off Road Truck. Also, remember, if you have any
questions or encounter any problems, you can contact your local distributor using the Customer Service Information on page 2.
l
Rage 1/18th 4WD Electric Off Road Truck Chassis
l
7.2V 1100mAh NiMH battery
l
AC Charger
l
Cirrus 2CAM Pistol-Grip Transmitter
l
Transmitter Antenna
l
Receiver Antenna Support Tube
step 1: installing the tRansMitteR batteRies
q
Push the transmitter antenna down into the moulded hole in the top of the
transmitter.
q
Thread the antenna (clockwise) into place and tighten it gently until it stops.
iMpoRtant Do not force the antenna into place or tighten it too strongly.
Doing so could cause damage to the antenna and/or transmitter.
q
Check to make sure that the transmitter power switch is in the OFF position
(pulled back).
q
Remove the battery cover from the bottom of the transmitter by pushing the
tab, then pulling it up.
o
Install 8 'AA' Alkaline batteries into the transmitter, double-checking to make
sure that the polarity (+/-) is correct.
iMpoRtant Pay close attention to the polarity of the batteries as shown
in the photo.
q
Reinstall the battery cover by firmly pushing the back of the battery cover down, sliding it back into the U-shaped slot, then pushing
the front down to snap it into place.
Upgrading your transmitter to use rechargeable NiCD or NiMH batteries is easy. All you need to do is purchase
8 'AA' rechargeable NiCD or NiMH batteries and a 70mAH charger that is capable of charging up to 8 cells
(9.6V). This will allow you to recharge the batteries without removing the batteries from the transmitter and it
will save you money in the long run, since you won't need to purchase Alkaline batteries when they run low.
tRansMitteR upgRade tip
waRning Never attempt to charge Alkaline batteries.
They are not designed to be charged and will leak or even
explode.