XTline XT106310, Руководство пользователя

Страница: 21 / 21

SPECIFIC SAFETY RULES
1. Make sure that the foreign objects such as nails and screws have been removed from the work before
commencing sanding.
2. Rags,cloths,cord,string and the likeshould never be left around the work area.
3. Always switch off before the sander is put down.
4. Do not force the sander.Let the tool work at a reasonable speed.Overloading will occur if too much
pressure is applied and the motor slows resulting in inefficient
sanding and may damage the sander motor.
5. When an extension cable is required,be sure that it has the right ampere rating for the tool and is in
safe electrical condition.
6. Fully unwind cable drum extension to avoid potential overheating.
7. Do not touch the moving sanding belt.
8. Worn,torn or heavily clogged sanding belts can not be continuely use.
9. Always connect the dust bag or use dust extraction system when sanding wood.
ASSEMBLY
Fitting The Dust Collection Bag
This machine is fitted with a dust extraction outlet and collection bag. We recommend that this facility is
used at all times, as well as using an approved face mask. Fit the dust collection bag onto the dust extraction
outlet
Switching on and off
Connect the plug to the power supply.To start the machine ,squeeze the ON/OFF trigger switch;To stop the
machine, release the ON/OFF trigger switch
WARNING! The sander is designed for dry sanding only and under no circumstances should it be used for
wet sanding
Lock-on Button
This machine is fitted with a lock-on button.When the on/off switch is depressed ,press lock-on button to get
continuous operation without depressing the on/off switch
Centralizing the sanding belt
Check that the sanding belt is running centrally before using .Centralizing the belt is necessary to stop the
belt running off the rollers. Turn the machine with the belt facing the operator
Start the Sander and observe how the sanding belt is running. If the sanding belt is seen to move along the
rollers in either direction, it will require centralizing before use.
Turn the centralizing knob either clockwise or anti-clockwise to adjust the belt tracking until the sanding belt
is running centrally. Run the Sander for a short time. If the belt is
MAINTENANCE
WARNING. Always ensure that the tool is switched off and the plug is removed from the power point before
making any adjustments or maintenance procedures.
Keep the tools air vents unclogged and clean at all times.
1. Regularly check to see if any dust or foreign matter has entered the grills near the motor and around
the trigger switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes
whilst cleaning.
2. Re-lubricate all moving parts at regular intervals.
3. If the body of the sander needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used
but nothing like alcohol, petrol or other cleaning agent.Never use caustic agents to clean plastic parts.
CAUTION!Water must never come into sparking seen through the ventilation slots. When the carbon
brushes have worn down to approximately 4-5mm, they will require replacing.
Caution! Make sure that the sander is isolated from the mains power supply before fitting accessories,
maintenance and adjustment if in doubt consult a qualified electrician.
Place the sander on a workbench and using a screwdriver remove the carbon brush housing cover (see 1 of
Fig.10).
Remove the carbon brush from the brush housing and replace it with a new one. Slide the new carbon brush
(see 1of Fig.11) into the brush housing. Repeat this procedure for the other carbon brush. Then replace the
carbon brush housing cover.
Note: carbon brushes must be replaced in contact with the sander.
4. During use, the carbon brushes will wear down and will be indicated by a possible loss of power and
excessive