XTline XT106150, Руководство пользователя, Страница: 22 / 24

ELECTRICAL SAFETY
The electric motor has been designed for one voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your tool is double insulated in accordance with EN 60745; therefore no earth wire is required.
ASSEMBLY AND ADJUSTMENT
NOTE: Before using the tool, read the instruction book carefully. Prior to assembly and adjustment
always unplug the tool. Prior to assembly and adjustment always unplug the tool.
KEYLESS DRILL CHUCK
• The chuck is rotating counterclockwise until the tool can be inserted. Finally, twist the chuck
clockwise until locking.
KEY TYPE DRILL CHUCK
• Open the ey type drill chuck by turning until the tool can be inserted. Insert the tool. Insert the
chuck key into the corresponding holes of the key type drill chuck and clamp the tool uniformly.
AUXILIARY HANDLE
• Operate your ma hine only with the auxiliary handle.
• The auxiliary handle can be set to any position for a secure and low-fatigue working posture.
• Turn the bottom part of the auxiliary handle in anticlockwise direction and insert the depth stop.
• Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth
stop correspond with the desired drilling depth X.
• Afterwards, tighten the bottom part of the auxiliary handle again by turning in clockwise direction.
The knurled surface of the depth stop must face upward.
WORK PREPARATION AND START-UP