XTline XT10608, Оригинальное руководство пользователя

Страница: 12 / 12

3
.
INTENDED USE
GUN HANDLING
The first requirement for a good resultant finish is the proper handling of the gun. The gun
should be held perpendicular to the surface being covered, and moved parallel with it. The
stroke should be released before the stroke is ended. This gives accurate control of the gun
and material.
SIPHON SPRAYING
Set atomization pressure approximately 50 psi for lacquer and 60 psi for enamel, test spray.
If the spray it too fine, reduce the air pressure or open fluid control screw. If the spray is too
coarse, clode the fluid screw. Adjust the pattern width and repeat adjustment of spray if
necessary.
PRESSURE SPRAYING
After selecting correct size fluid orifice, set fluid pressure for desired flow. Opet atomization
air and test spray. If spray is too fine, reduce air pressure. If spray is too coarse, raise air
pressure. Adjust pattern width and repeat adjustment of spray. Keeping fluid control screw in
open position will reduce fluid needle wear.
NOTE : To reduce overspray and obtain maximum efficiency, always spary with the lowest
possible atomization air pressure.