TOOL CHOICE
Use SDS clamping tools for hammer drilling and chiseling. Use chuck for wood and metal dirlling and
tightening. Chuck instalation (B) / SDS-chuck (D)
B,D: Clean the chuck before operating and lightly lubricate the tool. Insert the tool into the chuck with
rotation motion until secured. Check by pulling. Remove the tool by holding the chuck sleeve and pull out
to the opposite direction.
C: For SDS chuck replacement hold a flange (a) and pulling (b).
TOOL REPLACEMENT
a) Clean the chuck before operating and lightly lubricate the tool. Insert the tool into the chuck with
rotation motion until secured.(E).
Remove the tool by holding the chuck sleeve and
pull out to the opposite direction.(F)
b) tool with cylindrical shank: open
chuck jaws by turning counterclockwise, insert the
drill into the jaws and tighten again. By enabling
the chuck, the drill can be removed again.
DRILLING DEPTH ANDUSTMENT
The drilling depth may be adjusted by the drill stop which can be easily inserted into the holder on the tool
grip by depressing and holding the switch and inserting into the groove. Set the drill stop to the requested
drilling depth.
WORK MODE
Do not set the work mode while operating the tool!
Choose the work mode by rotating the switch to the requested position.
I
I
I
I
I
II
Impact drilling
concrete and stone
Drilling wood
and tighteting
Cutting postition
setup
Cutting
