WORK PREPARATION AND USE
When using tool, basic safety precautions should always be
followed to reduce the risk of personal injury and damage to
equipment. Read all instructions before using this tool!
1. When attaching the polishing wheel to your angle grinder, disconnect a corded one from
the power source.
2. Always disconnect the attachment from your angle grinder when cleaning or inspecting it.
3. Do not use in wet or damp locations.
4. Wear eye and hand protection when using and cleaning the wheel.
5. Wear a dust mask when operating.
6. Keep fingers and limbs away from the wheel when it is attached to your grinder.
7. Like any other polishing attachment,it can cause injury if not properly handle.
8. As with any power tool, the machine should be kept out of the reach of children.
9. Always adhere to all warnings and safety precautions provided with the angle grinder that
this attachment is to be used with.
WARNING: Some dust created by power burnishing, as well as contents from the machine
may contain chemicals known to cause cancer, birth defects or other reproduction harm and
can be hazardous to your health.
Assembly
The polishing attachment is applied with M14-thread angle grinder with no load speed less
than 4000rpm.Please ensure that the power is cut off and unplug the machine before the
installation of this polishing attachment.
Step
1:
1. Choose the correct clamping washer (a) for
your angle grinder
2. Place the proper washer to your angle grinder
a) Optional washers
b) Position of gear box for washers
Step
2:
1. Assemble the dust extraction guard to the right position and
screw it with the hex wrench
2. Make sure the locating pin is consistent with your grinder’s
washer(e), or the polishing pad has risks of interfering with the
rubber part.
c
)
Dust Extraction Guard
Step
3:
1. Press the spindle lock button to ensure the spindle
keeps still
2. Screw the random orbit attachment to the spindle
, tighten by
hand
d)
Random Orbit Attachment
e)
Spindle lock button
b
a
c
d
e
