TORQUE ADJUSTMENT
To select a torque value, turn the ring (2) so that the number or symbol corresponding to the given
value lines up with the stamped arrow on the top of the drill.
1.
Work mode selector
2.
Torque selector ring
3.
Scale
4.
Arrow
The number "
1
" corresponds to the lowest torque value, the number "
24
" corresponds to the
highest value. However, the indicated figures do not correspond to the values in "Nm" - i.e., the
value "1" on the selector is not equal to "1 Nm".
Try the appropriate setting of the tightening or loosening torque on a practice screw/workpiece, or
proceed from smaller values to higher ones until you reach the optimal setting.
TIP!
•
If you are going to tighten a large number of identical screws, take a moment to set the
correct torque. This avoids unnecessary cam out and damage to the bit and the screw
head after the screw is tightened to the required depth. At the same time, you do not need
to watch for the release of the trigger and possible overtightening of the screw, because
the tightening mechanism disengages at that moment.
•
The torque setting only works if the ring selector is in set in "
driving
" mode, i.e., if any
number from 1-24 is selected and set. If the drill symbol is set, the "
drilling
" mode is
selected, the torque clutch is automatically disengaged and the maximum torque value is
preset.
General table for recommended selection of suitable setting according to the material:
Mark
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Bolt
M4
M5
M6
Screw
Soft
wood
-
Ø 3,5 x 22
Ø 4,1 x 38
-
Hard
wood
-
Ø 3,5 x 22
Ø 4,1 x 38
*
the values in the table are only approximate, always choose the appropriate setting based on the
material, application or your own experience.
