d)
When not in use, idle tools should be stored in a place out of reach of visitors and children.
e)
Maintain careful manipulation with the tool. Check for deflecting or jamming of turning parts, damaged
parts or other conditions which may influence operating with the tool.
f)
Keep tools sharp and clean for better and safer performance. Properly serviced tools are less likely to
become covered in impurities and are better controlled.
g)
Use equipment recommended by the producer of your model only. Modifications and accessories used at
one tool may be dangerous when used with another model.
Warranty does not apply for accessories!
USING
1.
Hold tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring .Contact with a “live” wire will also make exposed
metal parts of the tool “live” and shock the operator.
2.
keep hands clear of moving parts .
3.
Do not touch moving parts, Allow the power tool accessories (bit and blades etc)to cool before touching
them .They can become extremely hot during use and can burn your skin.
4.
Always wear protective safety glasses when operating power tools. Wear a face mask when environment
is dusty .
WARNING: do not use abrasive wheels. Only use saw blades recommended.
BLADE REPLACEMENT AND INSTALLATION - fig. 4-6
- press and hold the spindle lock button (17). The spindle may rotate slightly
before the spindle lock fully engages
- loosen the saw blade locking hex polt (11) anti-clockwise.
- remove the hes bolt (11) and the saw blade locking flange (10). If the rear
flange (10.1) is removed for cleaning, ensure it is replaced in its correct
orientation.
- slide the lower blade guard (6) back using tab (6.1) and hold.
- ensure the specification of the replacement blade conforms with the machine
(i.e. outer diameter, width, rpm and type, e.g. woodcutting etc.). Before fiting
the new blade wipe a drop of oil on the inner and outer flanges where the arbor
locates.
- insert the new blade.
Note: Install the blade with the derection of rotation arrow matching the
direction of rotation arrows on the machine. The teeth face upward at the front
of the saw.
- reassemble the locking flange and secure the locking hex bolt (11) firmly.
Note: this saw is not designed to cut metal or masonry, it is intended for
cutting wood and analogous materials only.
On/Off trigger switch - fig. 7
the trigger switch (1) is operated in conjuction with a safety release button (2)
so that it is not possible to start the circular saw by accident.
- to start saw, press the safety button (2) first and then depress the trigger
switch (1). Always wear ear defenders during use.
Dust extraction - fig. 8
inhalation of dust particles can be detrimental to health. The dust outlet (8)
must be connected with a dust extraction machine.
Note: Due to outlet diameter, a size adaptation may be necessary.