XTline RO700, Руководство пользователя

Страница: 54 / 58

1) Pulley
2) Collet nut
3) Collet cone
1) Wrench
2) Pulley
3) Shaft lock
1. Collet nut
2. Collet cone
1) Pulley
2) Belt
1) Locking lever
2) Offset base
Mount the tool on the offset
base.
Put an end of the belt over
the pulley using a
screwdriver and make sure
that its entire bell width fits
over the pulley completely
Secure it with a locking
lever on the offset base.
1) Wrench
2) Hex wrench
3) Bit
To install the bit fall the tool with the offset base on its side. Insert the hex wrench into the
hole in the offset base. With the hex wrench held in that position, insert the bit into the collet
cone on the shaft of the offset base from the opposite side and tighten the collet nut firmly
with a wrench. To remove the bit at replacement, follow the installation procedure in reverse.
Offset base accessories not included
Offset base (D)
Offset base (optional acces s ory) is
convenient for work in a tight area
such as corner.
Before installing the tool on the offset
base, remove the collet nut and collet
cone by loosening the collet nut.
Install the pulley on the tool
by pressing the shaft lock
and firmly tightening the
pulley with a wrench.