MAINTANCE
WARNING: Remove the plug from the socket before carrying aut any adjustment, serv1cing _ or
maintenance.
When all the adjustments, settings or maintenance have been done, make sure that all keys and wrenches
have been removed and that all screws, bolts and other fittings are securely tightened.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage your power tool.
lf the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord available
through the service
1. PRECISION SETTING OF ANGLES (SEE FIG M1,M2)
While the machine has been factory set, it is advisable that the 0° setting of the rotary table and the 90°
perpendicular setting of the tilt be checked, as these positions may have moved in transit. [Ensure power is
disconnected while making these adjustments].
To confirm the 0° rotary table setting, set the rotary table at 0° and tighten the rotary table locking knob.
Check that the angle between the straight guide and the blade is 90° using a try square lbi, not supplied) as
shown in Fig. M1. lf the angle requires adjustment, loosen the locking screws [c) for straight guide, and
align the fence against the try square.
Re-tighten the locking screws [c) for straight guide.
2. CHANGING THE SAW BLADE (SEE FIG P1-P4)
Disconnect the saw from the power supply.
Press the blade spindle lock [24) and rotate the blade until it is locked, then loosen and remove the blade
securing bolt, the outer flange with the socket wrench in clockwise direction.
NOTE: Blade securing bolt has a left hand thread.
Remove the bla de, (we recommend the use of a stout glove for this). Clean any saw dust
and debris from the arbor and saw blade securing flanges.
To refit the blade, follow the above procedure in reverse order. lf you want to take the inner flange aut for
cleaning, refit it as shown in Fig. P4
CAUTION: ALWAYS install the hlade with the hlade teeth and the arrow printed on the side of the hlade
pointing down at the front of the saw. The direction of hlade rotation is also stamped with an arrow on the
upper hlade guard.
NOTE:
To turn the laser on, first insert the
supplied batteries into the appropriate
slot.
