UB2.5 Upright Bike
5
Handlebar, Seat, Pedals & Console
2
1. Attach the Handle Bar (
3
) onto the Console Mast (
2
) with the Button
Head Socket Bolt (
19
). Tighten using the M5 Allen Wrench (
43
) to lock
the handle bar in place. Route the hand pulse sensor cable (
82
) through
the console mounting plate as shown below.
2. Connect the console cable (
80
) and Hand Pulse Sensor Cable (
82
) to
the Console (
48
). Mount the console on the Console Mast (
2
) with four
Phillips Head Screws (
41
). Tighten using the Phillips Head Screw Driver
(
43
).
3. Use the 15 mm Wrench (
79
) to install both Pedals (
15
left and right)
on the crank axle. The left pedal is a reverse thread and will screw in a
counterclockwise direction. The pedals are marked with an R or L on the
end of the threaded pedal axle. Make sure to tighten the pedals firmly
or a clicking noise can occur during pedaling. It may be necessary to
retighten the pedals after use if clicking occurs.
4. Locate the Carriage Bolt (
71
) and slide through the Seat slider bracket
(
20
) and the seat post (
6
). Secure the slider with a Flat Washer (
72
) and
the fore/aft adjustment Knob (
52
).
Hardware Step 2
#19
. M8 x 30mm
Button Head Socket
Bolt (1 pc)
#41
. M5 x 12mm
Phillips Head
Screw (4 pcs)
#71
. 3/8” x 1-1/2”
Carriage Bolt (1 pc)
#72
. 3/8”
Flat Washer (1 pc)
Содержание UB2.5
Страница 12: ...10 UB2 5 Upright Bike Pre Set Programs P2 P13 ...
Страница 19: ......
