FS3.0 Elliptical
7
#43
. 5/16” x 3/4”
Button Head Socket
Bolt (1 pc)
#52
. 5 x 12mm
Sheet Metal Screw
(4 pcs)
#55
. 5/16”
Nyloc Nut (2 pcs)
#56
. 5/16” x 1-3/4”
Button Head Socket
Bolt (2 pcs)
#100
. 8.5 x 23 x 1.5T
Flat Washer (1 pc)
3
Hardware Step 3
Left Swing Arm
1. Locate the Left Swing Arm (Upper) (
7
) and slide it through the Swing
Arm Bushing (
23
); secure it to the Lower swing arm (
5
) with two Button
Head Socket Bolts (
56
) and two Nyloc Nuts (
55
). Tighten using M5 Allen
Wrench (
68
).
2. Slide the Handle Bar Cover (
78
) and Lower swing arm (
5
) over the
Swing Arm Axle (
22
). Attach with one Button Head Socket Bolt (
43
) and
one Flat Washer (
100
). Tighten using the M5 Allen Wrenches (
68
).
Note
: It is important to use two Wrenches (
68
), one on each end of the
Axle (
220
), when tightening the Bolts (
43
).
Note
: If there is a gap after assembling the swing arm, please install a
C-ring at Location B as shown above.
3. Install the outer covers (
79
) with four Sheet Metal Screws (
52
). Tighten
using the Phillips Head Screw Driver (
68
).
