Xterra FB150, Руководство пользователя, Страница: 14 / 16

12
FB 150 Folding Bike
6. ODOMETER : Monitor will display the total accumulated distance. The maximum value is
99.99 MILE.
7.
PULSE RATE: Press MODE button until “▼” appears at PULSE position.
Before measuring your pulse rate, please place your palms of your hands on both of your
contact pads and the monitor will show your current heart beat rate in beats per minute(BPM)
on the LCD after 6~7 seconds.
Remark: During the process of pulse measurement, because of the contact jamming, the
measurement value may be higher than the virtual pulse rate during the first 2~3 seconds,
then will return to normal level. The measurement value cannot be regarded as the basis of
medical treatment.
NOTE
1. If the display is faint or shows no figures, please replace the batteries.
2. The monitor will automatically shut off if there is no signal received after 4 minutes.
3. The monitor will be auto-powered on when starting to exercise push button w/signal in.
4. The monitor will automatically start calculating when you start to exercise and will stop cal-
culating when you stop exercising for 4 seconds
USER DIRECTION
HOW TO MOVE THE FOLDING BIKE
To move the Folding Bike, grasp the rear stabilizer and carefully lift it until the exercise Fold-
ing Bike can be moved on the front wheels. Carefully move the Folding Bike to the desired
location and then lower it.
Maintenance
The safety of this produce can be maintained only if regular periodic checks are made. Most
checks can be performed once a week. However some checks should be made before each
workout, and are indicated as such below.
Checks
• Check that seat nuts are secure, check before each workout.
• Check that pedals are tight, pedals can work loose over time.
• Check that stabilizer bolts are tight, check before each workout this.
• Check that handlebar is secure, if not, tighten, check before each workout this.
• Should a part become defective, replace it immediately. Do not allow use of the equipment
until it has been repaired.
Cleaning
A damp cloth is sufficient to clean most surfaces of this unit. Be careful not to drip water on
the monitor. A mild liquid soap may be added if needed.