16
performed once a week. However, some checks should be made before each workout, and are indicated as
such below.
Checks
• Check that seat nuts are secure, check before each workout.
• Check that pedals are tight, pedals can work loose over time.
• Check that stabilizer bolts are tight, check before each workout.
• Check that handlebar is secure, if not, tighten, check before each workout.
• Should a part become defective, replace it immediately. Do not allow use of the equipment until it has
been repaired.
Cleaning
A damp cloth is sufficient to clean most surfaces of this unit. Be careful not to drip water on the monitor. A
mild liquid soap may be added if needed.
HOW TO ADJUST THE REED SWITCH
The reed switch should be adjusted if the console does not display correct feedback.
The first step to remove the end cap ( 57) and flange nut (49 ), then use the special tools remove the right /
left crank.
The second step to remove all self-tapping screws ( 32) on the left and right chain cover and then take off
the left and right chain cover ( 69&70) from main frame .
The third step is to loosen the screw (30), rotate the sensor bracket (21) aligned with the magnet on the
pulley until the computer receive signals and tighten the screw (30).
The last step is attach the left and right chain cover (69&70 ) & crank (15 ) on main frame.
32
70
49
57
15R
27
21
30
HOW TO ADJUST THE DRIVE BELT
Содержание 16204993600
Страница 18: ...18 EXPLODEDVIEWDIAGRAM ...
