USB and eSATA to SATA II RAID Subsystem
User Manual
25
Chapter 2 Getting Started
2.1
Preparing the Subsystem and Powering On
Here are the basic steps to prepare the RAID subsystem for use.
1.
Attach network cable to the R-Link port and connect the other end of network
cable to your network hub/switch. Or as alternative for configuration, you may
connect the serial cable to the Monitor port and to the serial port of your
host/server.
2.
Connect the USB cable / eSATA cable to the USB port / eSATA port of the RAID
subsystem and to the host system or server that will use the storage.
3.
Connect the power cords to the AC input sockets. Plug the other ends of power
cords to the power source.
4.
Press the Power On/Off Switch at the rear of the subsystem.
2.2
Installing Hard Drives
This section describes the physical locations of the hard drives supported by the
subsystem and gives instructions on installing a hard drive. The subsystem supports hot-
swapping allowing you to install or replace a hard drive while the subsystem is running.
Each Drive Carrier has a locking mechanism. When the Lock Groove, which is located
in carrier open button, is horizontal, the Drive Carrier is locked. When the Lock
Groove is vertical, the Drive Carrier is unlocked. Lock and unlock the Drive Carriers
by using a flat-head screw driver.
a.
Make sure the lock indicator is in unlocked position. To pull out a disk tray, press
the carrier open button.
Carrier
Open
Button
b.
Pull out an empty disk tray. Pull the lever handle outwards to remove the carrier
from the enclosure.
Содержание XL-RAID-2123ISSA
