XTEMP ENVIRONMENTS (SHANGHAI) CO., LTD.
http://www.xtemp-usa.com/
19
/
31
DSGO0708-2-V211119/UXP8011-CD6400/CLASS I/NFL/RT+5~+100°C
Chapter 3 Controller Descriptions and Operation
3
3.1.2 Working status indicating
Heater: Press
for more than 2 seconds to initiate the circulating pump. Orange LED will be
steadily lit with full power heating; When LED flashes, the heating power is automatically
adjusted to meet actual need. LED flashing frequency keeps constant when temperature is
stabilized.
Compressor: Not applicable for this series of equipment.
Circulating pump: Press
for more than 2 seconds to initiate the circulating pump with LED
on, after which the heating operation is possible.
Alarm: Red LED is on, when there is beeping and warning for safety or error is triggered.
The warning or error of the sensor may be accompanied by the following:
Ht
：
When temperature in the bath is higher than the set value,
Ht
is displayed
Lt
：
When temperature in the bath is lower than the set value,
Lt
is displayed
Er01
: Warning of temperature sensor short-circuit.
Er02
: Warning of temperature sensor open-circuit.
ourh
: Warning of the bath temperature far beyond
Ht
.
Stb
: The independent safety temperature limiter (STB) is triggered; Press
(Fig 6-60)
and
to reset.
3.1.3 The key functions and navigate the menu
There’re 6 keys as follows. The function and their operation are summarized and listed in the table:
KEY NO
FUNCTION OPERATION
REMARKS
1
Initiate or
terminate the
temperature
control
Press and hold the
key for more than 2
seconds
Temperature regulating is possible only if the
circulating pump is activated and
temperature control is initiated.
2
Set the working
temperature
Press the button for
less than 1 second
SEt
is first displayed, then press
to enter,
change the digits by pressing
,
accept the setting by pressing
.
