XSPC RayStorm, Руководство пользователя

Страница: 13 / 18

Fitting the WaterBlock (Intel 2011)
1. Remove the plastic film from the base of the
waterblock.
4. Place a plastic washer and metal washer over each
of the four posts.
3. Place the waterblock over the M4 posts and onto
the CPU.
5. Place a spring over each of the four posts. 6. Remove the nut from each of the four bolts in the
intel screw set.
7. Place a nut over each post and gradually tighten
them. Make sure to apply equal pressure to each
spring.
2. Apply a thin layer of thermal paste to the CPUs heat
spreader.
The installation process below is shown without the tubing connected. This has been done so the installation process
can be seen clearly, without any obstructions.
Page 12/16