Xpresskit RKE9 Скачать руководство пользователя страница 4

Page 4

Vehicle Presets

Heater

Windshield Wipers & Radio & Headlights

When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start.
Settings for the blower motor (fan), front and rear, should not be left on HIGH. It is recommended to leave the settings on
LOW or MEDIUM instead.

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become energized while running
under remote start. When leaving the vehicle you must ensure that the windshield wiper and headlight switches are OFF.
Leaving the headlight switch ON on certain types of vehicles could cause them to remain ON even after remote starter
shut down, resulting in a dead battery.

Remote Starting Your Vehicle

1. Press the

button for approximately 1 second and release.

2. The remote will beep once.
3. The remote will confirm the remote starter’s activation by beeping 3 times.

With the vehicle running under remote control, press the UNLOCK button to disarm and unlock the doors. Enter the
vehicle and do the following:

Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK position while the engine
is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Driving Off

§

§

Remote Starter Features

Remote Door Locks

Remote Trunk Release

If your Remote Car Starter was installed with the Remote Door Locks option, you will have the convenience of remote
keyless entry.

To UNLOCK your doors and DISARM the system:

1. Press and hold the UNLOCK button for approx. 1 sec.
2. The remote will beep twice to confirm unlocking of the doors.

To LOCK your doors and ARM the system:

1. Press and hold the LOCK button for approx. 1 sec.
2. The remote will beep once to confirm locking of the doors.

If your system was installed with the Remote Trunk Release option, you can open your trunk by pressing the

button

until the remote beep once..

1-way & 2-way LED Remote Start Kits

Rev.: 20101109

Model: RKE9

© 2010 Directed Electronics. All rights reserved.

The Mobile Integration Systems

Содержание RKE9









Отзывы: