Page 4
Rev.: 20100413
© 2010 Directed Electronics. All rights reserved.
FORD TAURUS 2010
Push-to-start
*Default Option
Features
Operation
Option
1
Not available
Not available
Disabled
Enabled*
OFF*
ON
2
Tach output
Unlock Driver Priority
3
Features and Options List
CANMAX400DEI-LINCOLN1
Please Note:
Jumper
position
When a CANMAX400DEI is used in D2D with either Viper , Clifford
or Python , the
jumpers on the remote starter
be placed in the
position.
™
™
™
MUST
Horizontal
1
2
4
3
5
6
3 sec.
ENGINE
START
STOP
PUSH
Caution!
The 20 pin connector can be easily plugged in backwards.
Connect the 20-pin harness.
Remove cover from the module and cut the lip to allow docking
of the CANMAX400DEI.
Dock the CANMAX400DEI into the module.
The green LED turns ON for 3 seconds and
shuts off. The module is now programmed, you
can shut off the vehicle.
Make sure the key is in the vehicle. While
pressing the brake pedal, press once on the
push-to-start button to start the vehicle normaly.
When all connections are correctly done, the red
LED will turn ON.
Module Programming
Features Programming
To enter feature programming routine
Accessing another feature
Changing feature options
Once a feature is programmed
Turn the ignition ON, then OFF.
Within 5 sec, press and HOLD the integrated programming button (IPB). The orange LED turns ON after 3 seconds. Release
the IPB.
The green LED starts flashing slowly one time to indicate the feature number is 1. After a short delay, the red LED flashes
rapidly one time to indicate the current option of feature 1. It repeats until next action happens.
Press and release the IPB a number of times to advance from the current feature to the next desired
.
The green LED flashes slowly the number of times equal to the feature number. After a short delay, the red LED flashes rapidly
one time to indicate the current option of the current feature. It repeats until next action happens.
Press the arm or disarm button on aftermarket transmitter to change the option of the selected feature.
The red LED flashes rapidly the number of times equal to the current option number. After a short delay, the green LED flashes
slowly the number of times to indicate the current feature. It repeats until next action happens.
Another feature(s) can be programmed.
The feature programming can be exited.
When the maximum number of feature or option is reached, the will LED starts flashing again from the first feature or
option.
-
-
-
-
-
-
-
-
-
feature
Exiting feature programming
-
-
No activity for 30 seconds; after 30 seconds, the orange LED will turn ON for 2 seconds to confirm exiting.
OR
Press and HOLD the IPB for 3 seconds. After 3 seconds, the orange LED will turn ON for 2 seconds to confirm exiting.
Integrated
Programming
Button (IPB)
Module Reset
3
Dock the module into the remote starter to power it up.
(Make sure your remote starter is connected to a source of power.)
1
2
4
Connect the 20-pin harness.
Press and hold the Programming button.
When the LED turns ON orange, release the Programming button.
Once the LED turns ON red, the module reset is complete.
&
&
ON SOLID
ORANGE
ON SOLID
RED
