Plug the filler into a wall outlet. Turn on the Power
Switch. DO NOT turn on the Pump Switch at this time.
To set the fill height of your machine, you will need to
fill one bottle by hand to your desired level.
NOTE:
If your machine has the gas sparge option, make
sure the gas supply is turned off as you adjust the shelf.
•
Slide the filled bottle onto any of the four spouts and
place the bottle on the shelf if equipped with the gas
option. The green light will take a few seconds to
illuminate as the purge cycles operates without gas
connected.
•
While holding the shelf, loosen the adjustable knobs
on either side so the shelf moves freely.
•
Slowly raise the shelf until the green light goes off.
Once that light goes off, you know you have found
the height to set the shelf for bottling.
•
Note which holes on the side of the machine are
aligned between the filler body and the adjustable
shelf. Install the knobs to hold the shelf in place.
265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | [email protected]
7
| XpressFill Systems LLC
