https://www.XPOtool.com
Item 61544
Page 5
The Tool Experts
05 2021
-1
Functions
Caution!
•
This water pump has a water-sprinkling protection feature and should be placed only in a dry
environment. Never place the water pump or operate it in the rain or in a humid area.
•
This water pump should not be used with flammable or harmful liquids.
•
Dry-running of the water pump must be avoided under all circumstances.
•
This water pump is for processing clean water. The scope of its application includes irrigating
the garden, water supply to a household, sprinkling in a garden or on farmland.
•
This water pump may not be exposed for longer periods of time to impurities, sand, stone,
sticky substances, etc., mixed in with the conveyed media. For the conveyed media may con-
tain chemical corrosive substances, it is necessary to pay special attention to preventing influ-
ence by these on the material of the pump body. It is not permitted to use this water pump to
convey drinking water.
Caution!
If this water pump is used in a swimming pool, garden pond or similar pools, the pump must
be supplied through a residual current device (RCD) having a rated residual operating current not
exceeding 30 mA. Always keep it in a working state to ensure the safety and reliability of the water
pump. In addition, the pump should be placed on a stable base to prevent it from falling down.
Electrical connection
General description
Danger:
During the installation of the water pump, the power supply to the water pump must be
switched off.
Caution:
During the installation of the device, it is necessary to keep it under dry and well aired, at an
ambient temperature below 40
℃
. Before use, the water pump should be inspected for safety to en-
sure that there is no damage to the power cable or the plug.
Electrical connection
Danger:
The electrician responsible for installation must check to ensure that the electrical connection
is in accordance with the standard, including the earth terminal. The water pump must be well earthed.
Commissioning
The pump is not a self-priming pump, this means that the suction hose should first of all be fitted with:
•
a non-return valve with filter; this ensures that, after disconnecting the pump, the hose and the
pump do not run dry. This part of the hose is suspended in the water to be pumped away,
•
a hose with coupling nut; this end of the hose is attached to the front of the pump,
•
both accessories should be securely screwed on to the hose using the hose clip supplied.
•
Before fastening the hose to the pump, it is best to fill it with water first. After this you can
screw the three-way tap or anther 1
″ connector to the outlet of the pump; being on the top of
the pump.
•
Then you should loosen the small screw cap on top of the pump housing and fill the pump
housing with water through the opening; then re-seal it.
•
If the pump housing and the hose have both now been filled with water, you can switch on the
pump using the on/off switch.
•
The pump now immediately begins to pump water.
•
If the pump is subsequently switched off again, water remains in the pump housing and the
hose which means that when the pump is next switched on it will pump water immediately.