https://www.XPOtool.com
Item 62353
Page 7
The Tool Experts
05 2022-1
Starting (Fig.
5)
First press the locking button and then the start switch.
Speed controller (Fig.
4)
First turn on the power switch and then set the desired speed on the speed controller.
Figure
4
Figure
5
Stopping (Fig.
5)
Release the start switch to stop the machine.
Maintenance
•
Proper maintenance of the machine can extend its service life.
•
The handle switch must always be in perfect condition and well maintained.
•
The stirrers should be cleaned when the process is finished or if they are not going to be used
for a long period of time. The stirrers should be easy to clean under running water or with quartz
sand.
•
Do not apply excessive pressure when using the machine, e.g., avoid violent impacts, as the
machine is very likely to be damaged.
•
When using the device, it must be ensured that the noise exposure is kept as low as possible.
Therefore, always provide the opening in the hexagonal socket with the appropriate protective
cover and note that the ventilation slots of the motor housing must not be covered during oper-
ation.
•
There must be no flammable materials in the machine or in its immediate vicinity.
•
The ventilation slots must be cleaned regularly.
•
Only use identical original spare parts if individual parts are damaged and need to be replaced.
•
The carbon brushes must be checked and serviced after 60
hours of operation. Replace the
brushes in good time when they are worn out. Proceed as follows:
a)
First disconnect the machine from the power supply.
b)
Then take out the brush caps with a flat-blade screwdriver.
c)
Finally pull out the carbon brushes and insert new ones.
