https://www.XPOtool.com
Item 60326
Page 3
The Tool Experts
09 2022-1
Introduction
Thank you for purchasing this quality product.
To minimise the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Fasten the metal mounting to the wall or ceiling with screws.
1.
Drill 4
M8 holes into the wall to match the holes located in the mounting bracket.
2.
Connect the hose reel to the mounting bracket with the pivot pin. It is recommended to install
the mounting bracket 0.5
m from the floor.
3.
Pull the hose. It has 2–3
lock positions per meter.
4.
Please do not pull the hose after it has entirely been pulled out. Otherwise, it might retract sud-
denly.
5.
Please hold the nozzle when the hose is in retraction until it is finished.
Troubleshooting
The most common malfunction is that the hose cannot be retracted automatically after being fully ex-
tended. The reason may be that the hose end is locked as the stop-anywhere mechanism stays in the
locking point and there is no further hose to be pulled out for release.
There are two ways to solve this:
1.
Hold the hose and the yellow mark and pull it with a jerking motion until the hose retracts again.
2.
Place the hose reel with its right side down. Pull the hose until it retracts again.
Technical data
Item №
Hose length
(m)
Hose
material
Working pres-
sure
(
㍴
)
Tempera-
ture
(
℃
)
Outer casing
material
Size of inlet
(inch)
60326
15
PVC
8
-5–45
PP
¼
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction
manual require the written permission of WilTec Wildanger Technik GmbH.
