Xplore Hub 5, Руководство пользователя, Страница: 12 / 24

X P L O R E H U B U S E R G U I D E 8
Hub 5
Reset
Setting up your Hub 5
(Continued)
To Connect through Wi-Fi: Connect
using the WLAN SSID (Network Name)
and password (WLAN Security)
printed on the back of the router
Once connected, open a browser
and make sure you can access
different web pages.
Once browsing, Internet LED light
at the front of the Hub would be
blinking Green
Tip: If still unable to connect, or if the Internet LED light is solid red ,
perform a factory reset by holding the Reset button on the back
of your Hub for 10 seconds, then wait three minutes before turning
back on.
1. If you already have Xplore Whole Home
Wi-Fi Units that are in use, you will need
to perform a factory reset first using
the button on the back (hold
for 10 seconds, wait 3 minutes
for it to power fully). Repeat
for all units.
2. Plug the first new or existing
Whole Home Wi-Fi Unit into a
power outlet near the location
where you would like it installed.
Wait 3 minutes for it to start up.
LED Light at the front of the Whole
Home Wi-Fi Units would be solid Red
while unit is booting up
Connect Your Wi-Fi Units for Whole Home Wi-Fi
Step 4: Connect Your Whole Home Wi-Fi
The Xplore Whole Home Wi-Fi network enables you to have superior
coverage in every room in bigger homes. It does that by deploying one or
more Whole Home Wi-Fi Units in different locations to extend your Hub’s
signal. If you do not have this option you can skip this step.
Back of Whole Home Wi-Fi Unit
Front view of
Whole Home
Wi-Fi Unit