Xplore Blaze, Руководство пользователя, Страница: 20 / 24

19
ADJUSTING (CENTERING) AND TIGHTENING THE TREADMILL
The treadmill is properly centered by the factory. However, after a long usage you must check to make
sure the treadmill is still centered on the running deck and that it still runs with enough tension to ensure a
smooth run. If this is not the case, the treadmill has to be adjusted.
To do this, proceed as follows: If the treadmill is running to far to the left, the turn the left screw clockwise
so that the band will be adjusted to the right. If the problem is not corrected after doing this, then please
turn the right screw as well, but counter clockwise, until the band is the middle and has the correct
tension.
If the bank is in general too loose (fluttering), then turn both screws clockwise using the hexagon wrench
until it is tighter. If you notice that the band “wanders” to the left or the right during training, then repeat the
adjustment procedure and re-centre it.
Depending on the circumstances, this could be necessary a few times.
Warning: When adjusting the band with the screws, do it carefully and with as few turns as possible
because over tightening the screws could result in damages of the plastic end caps. Check the location of
the band during the centering procedure by walking a little bit in between adjustments.
If the band has been correctly adjusted, it will be sufficient to check the position in regular intervals of
several weeks.
In addition, the correct centering must be checked after each time the treadmill is folded up as well as
after every transport.