Xpelair 93011AW, Инструкция по установке и обслуживанию

Страница: 8 / 12

For Australia Only – LV100R / LV100S / LV100PR / LV100PS / LV100PIRR / LV100PIRS
Connection to the supply can be made by a flexible 2-core cable complete with 3 pin plug for insertion into an approved 10A
GPO or directly wired through an approved 10A wall mounted surface switch with at least 3mm clearance between contacts.
For Australia Only –LV100TR / LV100TS / LV100HTR / LV100HTS / LV100HPTR / LV100HPTS
These models are permanently connected to the supply and operation is controlled by a remote switch. They should be directly
wired to the supply through an approved 10A wall mounted surface switch with at least 3mm clearance between contacts.
Preparing the Fan for installation.
1. Remove the front cover by depressing the latch on the underside of the cover and pulling off the front cover from the
bottom (See Figure C).
Mark the position of the back-plate
2. Hold the back-plate so that the level line marked on it is orientated horizontally.
3. Carefully insert the fan tube into the wall duct.
4. Mark on the wall the positions of the fixing holes in the back-plate.
5. Remove the back plate from the ducting.
6. Drill screw holes in these positions if necessary, and fit wall plugs and screws as required.
Mount the back-plate.
7. Push the ribbed gasket onto the duct section of the back plate (see Figure D).
8. Push the larger diameter piece of the telescopic wall tube onto the ribbed gasket. Cut the tube to the required size
first if necessary.
9. Feed the mains cable through the cable entry hole in the back plate to the terminals.
10. Insert the fan tube into the wall duct/ceiling as before.
11. Fasten the back-plate to the wall/ceiling using appropriate fasteners supplied. See figure A.
12. If using screws, do not over tighten.
Mount the back draft shutter
13. Peel the backing from the foam strip supplied and attach it around the outside lip on the backdraft shutter.
14. Go outside. Holding open the top and bottom vanes insert the lip into the wall duct.
15. Making sure that the back draft shutter is level, mark the positions of the two fixing holes in the top right hand and
bottom left hand corners.
16. Remove the back draft shutters from the wall duct.
17. Drill screw holes in marked positions and fit the remaining wall plugs.
18. Holding open the top and bottom vanes, refit the back draft shutter and fasten it to the wall using the screws. Do not
overtighten screws.
19. Make sure that the vanes open and shut fully.
Mounting the transformer (Figure F)
The transformer can be fixed directly to the wall.
When wall mounting, the transformer must be orientated as shown in Figure G to fulfil ingress protection requirements.
20. Remove the screws securing the cover, remove the cover.
21. Position the transformer on the wall and mark the two fixing holes ‘A’ and ‘B’.
22. Drill and plug the two holes and fix the transformer to the wall.
THE TRANSFORMER MUST NOT BE COVERED BY LOFT INSULATION
Wire the electrical connections.
23. Make sure the mains supply is isolated. Switch off the mains electrical supply and remove fuses.
24. Feed the cable to the terminal block. Wire the fan as shown in Figure J using the diagram appropriate to the fan model.
25. Connect the cable from the isolating switch to the electrical supply wiring.
If working above ground floor level, safety precautions must be observed.
If installing in a ceiling, appropriate termination ancillaries are required. Follow
instructions provided.