Xoro HST 550S, Быстрый старт

Страница: 56 / 62

ENG 16
Engl
ish
Search
The Menu provides some options to adjust the Channel
Search setting , select an option and press
OK to enter
the setting , press BACK to exit the menu.
Dish Setup
Add satellite:
To add a new Satellite, you have to know its technical
parameters. Press
RED button to add a new satellite.
Delete satellite:
Press
YELLOW to delete a selected Satellite from the
List.
Configure the settings of satellites:
Satellite List: Press Up/Down to select a satellite, the
configuration would be shown at right side.
•
LNB Type: Press OK to show the edit of LNB Types which is shown as frequencies of the
local oscillator. You also can Edit frequency by User Mode.
•
LNB Power: Press OK to set the LNB power.
•
22K: Press OK to set the 22KHz on/off. This signal controls the Oscillator Frequency of an
LNB with two local Oscillator frequencies.
•
ToneBurst: Enable or Disable the ToneBurst switch
•
6.DisEqc Mode:
DisEqc 1.0 : Select the correct port up to 4 for the LNB
DisEqc 1.1 : Select the correct port up to 16 for the LNB
•
Motor: Setup for a Motor-Dish shall be made by experienced users only. Please refer to the
Manual of you Motor-Dish.
Satellite Scan:
1. Press
BLUE to open the menu of scan mode settings
2. Scan Mode : Press OK to select Default ,which scans the preset transponders ; Blind Scan
that firstly scan the band to get the transponders which can be locked, after gathering all
Transponders, then scan the transponders one by one to get the programs ;Network will
scan by NIT table
3. Crypted: Press OK to select "All channels" or "FTA channels"
4. Switch to the highlight [YES] and press OK to start scanning with the above settings.
DTV Player