Misgav Industrial Park, POB 60, D.N. Misgav 20174, Israel
Tel: +972-4-9951999; Fax: +972-4-9990287
PM0616.05 - CXR2000/CXR3000 CompletePBX Getting Started Guide (electronic version)
Page
1
of
5
CXR2000/CXR3000 CompletePBX: Getting Started Guide
Package Contents
CXR2000/CXR3000 (2U 19'' width unit)
Power cord
Support hardware for 19'' cabinet
CompletePBX software preinstalled on
the hardware
Prerequisites
You need a computer equipped with an Internet browser. Firefox is recommended. By default, the
CXR2000/CXR3000 will get its IP address from your DHCP server. To check the IP address or to
set the CXR2000/CXR3000
static IP
address you will need to connect a keyboard and a display to
the CXR2000/CXR3000.
Step 1: Powering Up the Unit
1.
For safety reasons, if the line wiring exits the building, it is essential to ground the unit.
Note: Not properly grounding this device will void your warranty!
a. Connect a grounding tab to the grounding screw on the rear panel.
b. Using 12-16 gauge wire, connect the grounding tab to a reliable ground.
Figure 1: Grounding Screw on CXR2000 Rear Panel
Figure 2: Grounding Screw on CXR3000 Rear Panel
2.
Connect a keyboard and a VGA/SVGA screen.
3.
Connect the unit to the LAN.
4.
Connect the power cord to the device and turn on the power using the switch on the rear panel.
The device startup process takes about 2 minutes. The startup time depends on the number of
telephony ports installed in your CXR2000/CXR3000 unit.
Step 2: Submit Warranty Activation Request
At this point activate the product warranty (a pre-requisite for submitting any request for technical
support). Go to
https://xorcom.com/xorcom-product-warranty
, complete and submit the form found
there.
Grounding
screw
Power Supply
Eth0
Eth1
IPMI
Grounding
screw
Power Supply