-18-
DIN REAR MOUNT(method B)
Install and Remove the Front Panel
，
not available for this
unit(fixed panel)
Installation using the screw holes on the sides of the
Unit.
Fastening the unit to the factory radio mounting
bracket.
1. Select a position where the screw holes of the bracket
and the screw holes of the main unit become aligned
(are fitted) and tighten the screw at 2 places on each
side.Use either truss screws (5*5 mm) or flush surface
screw (4*5 mm).
2. Screw(“T”Position).
3. Dashboard or Console.
Note: The mounting box,outer trim ring,and half-sleeve
are not used for method B installation.
Remove the front panel
Press “REL” button in the panel , pull out the A, then
slightly pull out B
Please see picture on the left
Install the front panel
Put notch B (shown as picture) onto buckle B, and then
slightly press A into the left side.
Note: Please don’t insert finger in control panel. If
connector is dirty, use a clean soft cloth to wipe it clean.
A
B
A
B
XM-VRSUN728
