Xo XOC VISOR, Руководство пользователя

Страница: 19 / 80

- 19 -
30"
3
4
7
1
G
D
E
B
E
E
G
D
1
2
3
A
30"
E
G
E
4
5
INSTALLATION OF THE HOOD ON THE LOWER PART OF THE WALL UNIT ONLY FOR 30".
This model includes side installation to the wall unit by using 2 brackets B (figure
3
besides
steps 3-4, indicated in figure
1
).
1- Position template B on the wall unit, bearing in mind the measurements and the
minimum distance from the hob.
- Mark the references to fix brackets A to the wall unit, as indicated in figure
3
.
2 - Position the second template E on the side of the wall unit and make sure that the line
matches up with that traced in figure
3
- step 1.
3 - Mark and drill the 4 fixing holes (figure
3
- step 2).
- Fasten the 2 brackets G to the wall unit using the 4 screws D (figure
3
- step 3).
- Fasten the hood to bracket G using the 4 screws E (figure
3
- step 4-5).
4- Remove pin Y from bracket A. Then place the insert X on the slot of the bracket A, as
indicated in figure
1
- step 3.
- Match the C screws with the L wascher and fix the A bracket to the cabinet as indicated
in figure
1
- step 3.1. Pay attention not to completely tighten screws C before the bracket
firmly reaches the wall unit (figure
1
- step 3.2). After any adjusting, tighten the bracket
to the body (figure
1
- step 3.3).
- Fasten screw D to the wall unit as indicated in figure
1
- step 4.
- Once you have fastened the hood to the wall unit, adjust the spacer L, with screws P, to
make the device line up the rear wall unit (figure
1
- step 5).
IMPORTANT - The range hood must be secured to wall studs or use drywall
anchors capable of supporting 75 lbs.