196
Activate support access
Activate support access interface isdn0
Select "yes" to configure and activate the dial-up interface for technical support.
Choosing "no" will disable the ISDN interface isdn0. Connecting to this interface will
be impossible in this case.
Activate support access interface isdn0
-
yes
Please read on at
(p. 196)
-
no
Please read on at
(p. 198)
ISDN parameters
Select the appropriate D channel protocol and configure the Multiple Subscriber
Number (MSN) on this page. These settings depend on your local telephone network. If
in doubt please check the documentation you received from your telephone company.
If SX-GATE is connected to a private branch exchange (PBX) please take a look at its
documentation or ask the person who's in charge of the PBX.
The SX-GATE ISDN card must be connected to a plug providing
an ISDN S0 bus. Point to multipoint is assumed, however
technical support can enable point to point mode.
ISDN protocol
First of all, select the appropriate D channel protocol. If the SX-GATE ISDN card is
connected directly to a socket of your telephone company then all over Europe you will
most likely have to select the Euro-ISDN protocol. Usually the same applies if SX-GATE
is connected to a PBX. However some PBX models use 1TR6 as internal protocol,
even if the public telephone network uses Euro-ISDN. In America you'll have to select
the NI1 protocol.
If the D channel protocol is not configured correctly, no ISDN
connection can be established.
MSN (resp. EAZ using 1TR6)
SX-GATE accepts incoming calls only if the MSN has been configured properly. Usually
it is not necessary to configure the correct MSN for outgoing calls. However if you
Содержание SX-GATE
Страница 1: ...State 2016 12 13 V7 0 2 0 User Guide ...
Страница 92: ...12 1 Setup 92 There s no way to restore a purchased certificate without backup ...
Страница 126: ...12 3 3 Groups 126 12 3 3 C Usage This table show in which settings the definition is used ...
Страница 476: ...15 3 Apple iPhone 476 ...