37
1. Start and run the engine at idle for 3-5 minutes, then
stop it.
2. Wait about 2-3 minutes to allow the oil to properly
distribute itself in the engine.
3. Stand the motorcycle on a support stand so that it is
not leaning to either the right or left.
4. Remove the oil filler cap
, wipe it clean, and insert it
back in to its place but DO NOT screw it back in.
5. Check that the oil level is within the (1) & (2) hash-
marks on the dip stick as in Fig. 1
6. If the oil level is at or near the upper mark (1), you do
not need to add oil.
7. If the oil level is at or near the lower mark (2), you
need to add oil.
8. Add the recommended oil until the upper mark (1), is
reached. (DO NOT OVERFILL)
9. You can also check the oil level through the sight glass
10. Repeat steps 1 through 5.
11. Reinstall the dipstick and check for any leaks.
12. The V4/RM model do not have a dipstick, please make
sure the oil level is accurate by viewing the level in the
sight glass on the V4/RM model shown above.
Fig. 1
Improper disposal of drained fluids is harmful to
the environment.
NOTICE
Do Not dispose of drained oil in an appropriate
manner. Most parts stores or auto shops do take
used oil.
NOTICE
If the oil filter and cap are not installed correctly,
it will cause serious engine damage.
NOTICE
ENGINE OIL Cont.
BASIC MAINTENANCE PROCEDURES
CHECKING & ADDING OIL
XZ250R V4 / RM
XZ250R - ZS
Allow the engine oil to circulate in the engine for
2 – 3 minutes before riding at start up. This will
give enough time for the oil to lubricate all critical
engine components. Failure to do so, will cause
engine damage.
NOTICE
Содержание XB31
