Getting started with xCORE VocalFusion Speaker
Your
Run Configuration
should now appear similar to the following (Figure
Figure 13:
Run Configu-
ration
settings
Check that
Target
is set correctly, as shown in (Figure
). If this is not the case,
ensure that the device is connected correctly and click on
Refresh list
. If this is
not enough, try to unplug and plug the xTAG adapter and use the
Refresh list
button again.
Click
Apply
to save the configuration.
Click
Run
to download the application to the
xCORE VocalFusion
board, and run it.
The board will now running the desired firmware.
6.1.1
Erase board
If the board is reset or power cycled, it will boot into any firmware programmed
in its flash. If firmware is ran rather than flashed, it is good practice to erase the
flash first. Should the board reset or power cycle after run, empty flash ensures it
will not run another version unexpectedly.
XM011320A
