XKL DarkStar DRA, Руководство пользователя

Страница: 38 / 72

28
DarkStar User Guide
3: Software
www.xkl.com
3.2.5.2 Telnet Access
Telnet access is disabled until the Virtual Terminal (VTY) password is set. VTY lines must also be configured to accept
connections via telnet. VTY lines can be accessed via any configured Ethernet port. Beware that if AAA new-model is set, then
AAA access rules apply instead of the requirements outlined here.
• The
password
command sets the password for VTY.
•
The
login
command enables remote login over VTY.
• The
transport input telnet
command configures VTY to accept login attempts via the telnet protocol.
The following example illustrates how to configure remote telnet access to all configured Ethernet ports:
localhost>
enable
localhost#
configure
localhost CONF#
line vty
localhost CONF-LINE-VTY#
password
new password
localhost CONF-LINE-VTY#
login
localhost CONF-LINE-VTY#
transport input telnet
localhost CONF-LINE-VTY#
end
localhost#
write memory
Are you sure? [yes/no]
yes
localhost#
TABLE 3.5
Console Jack Pinout Configuration
Pin Signal Comment
1 No connection
2 No connection
3 TxD
4 Gnd
5 No connection
6 RxD
7 No connection
8 No connection