XK041021/XK041022 – White/Amber LED Running Board Light
Wiring Diagram
Mounting Instructions
Permanent Mounting:
1.
Prep mounting surface:
Using isopropyl alcohol, thoroughly clean the mounting surface. Any dirt or debris left on the paint will
prevent the light bar from adhering properly. Let dry.
2.
Position light bar:
Remove red tape backing and loosely position the light bar onto the vehicle. Do not press firmly! Step back
to ensure that light bar is centered and straight. Once in position, firmly and thoroughly press onto the vehicle. Repeat for other
side of vehicle.
Removable Mounting:
1.
Prep mounting surface:
Using isopropyl alcohol, thoroughly clean the mounting surface.
2.
Install brackets:
Evenly space and snap
the brackets onto the light bar. With the
brackets snapped onto the light bar, use
masking tape and loosely position the bar
into place on the vehicle. Ensure light bar is
centered and straight and mark the position
of each bracket. Remove the light bar and
using the self-tapping screws, secure the
brackets to the vehicle.
3.
Install light bar:
Insert the top of the bar
into the brackets first and then push the bottom of light bar into the brackets. Repeat for other side of vehicle.
Wiring
1.
Begin by connecting the
RED
wire to a
constant
12V+ power source and the
BLACK
to ground.
2.
Using the supplied scotchloks, tap the white, yellow, and green wires into its corresponding wire following the diagram above.
Tap the
WHITE
wires into the positive courtesy door light wire on each side. Tap the
YELLOW
wires into the positive running
light wire. Then tap the
GREEN
wires into the positive turn signal wire on each respective side. Example: The green wire on the
driver side light bar should be tapped into the positive turn signal wire on the driver side of the vehicle.
3.
OPTIONAL:
The optional strobe mode is triggered with the blue wire.
If the blue wires are connected, the light bars will
perform an intense white/amber alternating strobe when hazard is on. If these wires are not used, the light bars will blink
amber in sync with factory hazard mode.
Tap the
BLUE
wires into the
opposite
side positive turn signal wire. Example: The
blue wire on the driver side light bar should be tapped into the positive turn signal wire on the passenger side of the vehicle.
Included with the kit is 12ft of blue extension wire. Use this to reach the opposite sides of the vehicle.
4.
Secure any loose wiring.
5.
Power on vehicle and test functionality.
