XK A300, Руководство пользователя

Страница: 8 / 21

6. Assembly of flat tail and vertical tail
6.组装平尾、垂尾
7. Assemble blade/fairing/install trim
7.组装桨叶/整流罩/安装装饰件
Figure 1. Thread the vertical-tailed steel wire out of the flat-tailed hole, align the flat-tailed wire with the
fuselage positioning slot and install it in place.
Figure 2. Align the vertical tail with the locating hole and install it in place.
Figure 3. Lock two 1.7 * 8PB screws on the fixing vertical screw hole at the bottom of the fuselage.
图1.将垂尾钢丝从平尾孔中穿出，把平尾对齐机身定位槽装到位。
图2.把垂尾对准定位孔装到位。
图3.在机身底部固定垂尾螺丝孔锁上两颗1.7*8PB螺丝。
Figure 1. Take out the nut fixed on the motor shaft, align the blade
with the flat position of the motor shaft and install it in place.
Figure 2. Tighten the nut with the multi-functional wrench in the accessory package. If the blade vibrates
during rotation,it can be taken out and installed in another direction.
Figure 3. Install the fairing onto the motor shaft and screw in a 2 * 8HM screw with an Allen screwdriver.
Figure 4. Apply proper amount of foam adhesive, silica gel and hot melt adhesive to the two grooves on
the upper wing.
Figure 5. Install the wing trim to the groove where the glue is applied as shown in the figure, with the tilt
angle towards the rear of the aircraft.
图1.取出固定在马达轴上的螺母，把桨叶对准马达轴扁位装到位。
图2.用配件包里面多功能扳手将螺母拧紧，转动时如果桨叶震动，可以取出换个方向安装。
图3.将整流罩装到马达轴，用内六角螺丝刀拧上一颗2*8HM螺丝。
图4.在上机翼有两个凹槽位置涂上适量泡沫胶，硅胶、热熔胶都可以。
图5.将机翼装饰件按图所示装到打好胶的凹槽位置，倾斜角度朝飞机尾部方向。
图1（ Figure 1） 图2（ Figure 2） 图3（Figure 3）
图1（ Figure 1） 图2（ Figure 2） 图3（Figure 3）
图4（Figure 4）
图5（Figure 5）
7