Xirrus XK-RDW-100-N, Быстрый старт, Страница: 19 / 28

Alternative Settings 17
Alternative Settings
Settings may be changed by selecting the appropriate page from the list on the left-hand
side of the WMI, as described in the procedures below. After making changes, you must
click the
Save button at the bottom right of the page to apply your changes and make
them permanent. To change settings not mentioned below, please see the Wi-Fi Array
User’s Guide .
The Arrays that are furnished with the RDK are shipped with several predefined wireless
networks (called SSIDs). Use them to easily set up your Array to offer an open or a secure
wireless network, with or without assigning DHCP addresses to clients.
Changes should be made in this order:
1. “Change the Array IP address (if needed)” on page 17 .
2.
“Set up an open or secure Wi-Fi network, with or without DHCP” on page 18 .
3. Make any other desired changes after the steps above are complete.
Change the Array IP address (if needed)
If the IP address of the Array was not set by DHCP, then the default address of the
Gigabit1 port is 10.0.2.1. Typically, you will want to replace this with an address that is
part of your subnetwork. Note that the assigned address
must be unique . If you duplicate
an IP address that is used by another device on your network, both devices using that
address may become unreachable!
1. On the left of the WMI, click Express Setup . ( Figure 13 ) Note that the current IP
address (in orange) is displayed in the top green bar.
Figure 13. Setting an IP address in the Gigabit section of the Express Setup page
2. In the Gigabit Ethernet 1 Settings section, set Configuration Server Protocol to
Static . Then enter the desired IP Address , IP Subnet Mask , and Default Gateway .
3. Click the Save button.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299