13
RJ-45 Cable
Follow the instruction below to waterproof the connector of the RJ-45 cable.
Plug the Ethernet cable to the connector
of the RJ-45 cable and coat the joint with
silicone gel. Make sure there is no gap
between the Ethernet cable and the
connector; otherwise, waterproof function
cannot be guaranteed.
IP66 RJ-45 Cable 1 / IP66 RJ-45 Cable 2
For IP66 RJ-45 cable 1 and IP66 RJ-45 cable 2, please use an RJ-45 IP66 plug
for connection to prevent water damage. Follow the steps below for cable
connection.
Step 1:
Loosen the thread-lock sealing nut on the RJ-45 IP66 plug. For IP66 RJ-45
cable 2, please take out the supplied connector from the RJ-45 IP66 plug first.
Then thread the Ethernet cable through the thread-lock sealing nut and the
RJ-45 IP66 plug. If the Ethernet cable is attached to a connector already, please
remove it first.
IP66 RJ-45
Cable 1
IP66 RJ-45
Cable 2
Step 2:
Carefully remove a section of rubber coating from the end of the Ethernet cable
to reveal the wires. Inset the wires to the correct pins of the connector. Plug the
Ethernet cable to the connector of IP66 RJ-45 cable 1 / cable 2.
