4
Part Number
18153, D 10/03/2017
Operation of Xintex Relay Control Module(s)
The RCM5 has a 6 position terminal strip located on the top face of the unit. Power must be
supplied to the unit, as well as the signal from a Xintex detection device. When the RCM5
receives the signal from the connected Xintex device, the relay is tripped. The RCM5 can be used
to interrupt a device’s ground and disable the device.
Locating a Xintex Relay Control Module
Locate the RCM5 in a convenient place near the Xintex detection device for periodic testing and
maintenance. Do not install in the bilge area, engine compartment or other hazardous locations.
Do not install in locations where temperature, moisture, and/or ultraviolet light affect operation.
This is not an ignition protected device.
Installation
Mounting the Relay Control Module
Use appropriate length #8, Pan Head screws to secure Mounting Base. Two styles of
3/4” length provided.
Do not over-tighten.
