Xinpu XP-R26A, Инструкция по эксплуатации

Страница: 12 / 18

APPLICATIONS
Rotation and hammering function
{
Drilling anchor holes
{
Drilling holes in concrete
{
Drilling holes in tile
Rotation only function
{
Drilling in steel or wood
(with optional accessories)
{
Tightening machine screws, wood screws
(with optional accessories)
Hammering only function
{
Light-duty chiseling of concrete, groove digging and edging.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilizes conforms to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while
the power switch is in the ON position, the power tool will start operating immediately, which could
cause a serious accident.
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness
and rates capacity. The extension cord should be kept as short as practicable.
4. Mounting the drill bit (Fig.1)
CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle.
NOTE
When using tools such as bull points, drill bits, etc., make sure to use the genuine parts designates by
our company.
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner into the tool holder until it latches itself
(Fig.1)
(3) Check the latching by pilling on the drill bit.
(4) To remover the drill bit, fully pull the
flex sheath
in the direction of the arrow and pull out the drill bit
(Fig.2).
5. Installation of dust cup (Optional accessories) (Fig.3)
When using a rotary hammer or upward drilling operations attach a dust cup to collect dust or particles
for easy operation.
{
Installing the dust cup
Use the dust cup by attaching to the drill bit as shown in Fig.3
When using a bit which has big diameter, enlarge the center hole of the dist cup with this rotary
hammer.
CAUTION
{
The dust cup are for exclusive use of concrete drilling work. Do not use them for
wood or metal drilling work.
{
Dump particles after every two or three holes when drilling.