Optional accessories are subject to change without notice.
Name of the parts
1.
Hammer rod protector
2.
Protective lining
3.
Move limited ring
4.
Shock Absorption Jacket
5.
Switch
6.
Speed Adjuster Function Knob
7.
Indicator
8.
Side Handle
9.
Function Knob
Assembly
Auxiliary Handle
Operate your power tool only with the
Side Handle
8.
The Side Handle
8
can be set to any position for a secure and low-fatigue working posture.
Loosen the Function Knob
9
, rotate the Side Handle
8
around the axis of the power tool to the required
position and tighten the Function Knob
9
again.
The Side Handle
8
can be mounted to a different position. For this, completely unscrew the Function
Knob
9
and then pull out the hexagon bolt upward. Pull off the Side Handle
8
to the side and turn around
the remaining clamping element by 18
0
。
Mount the Side Handle 8 in reverse order.
Changing the tool
Before any work on the power tool itself, pull the mains plug.
With the SDS-max tool holder. Simpler and easier tool changing is possible without additional aids.
The Hammer rod protector 1 largely prevents the entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that the Hammer rod protector 1 is not damaged.
A damaged
Hammer rod protector
should be changed immediately.
We recommend having this carried
out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end
of the tool.
Insert the tool in a twisting manner into
the tool holder until it latches itself.
Check the latching by pilling the tool.
Removing (see figure B)
Push back the Protective lining
2
and remove
the tool.
CAUTION:
The insert tool may become hot
During Use. There is a risk of burning the hands.
Wear
Protective gloves when changing insert tools.
