6
d)
Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool.
Power tools are
dangerous in the hands of untrained users.
e)
Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tool's operation. If damaged,
have the power tool repaired before use.
Many accidents are caused by poorly maintained
power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g)
Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a hazardous
situation.
5)
Service
a)
Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
b)
If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
Additional Safety Rules for Hammer
1.
Wear ear protectors.
Exposure to noise can cause hearing loss.
2.
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3.
Hold power tools by insulated gripping surfaces, when performing an operation where the
cutting tool may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live" and could give the operator an electric shock.
4.
W
ear a dust mask.
5.
Be sure the bit is secured in place before operation.
6.
Under normal operation, the machine is designed to produce vibration, the screws and bolts can
come loose, causing a breakdown and accidents. Check tightness of them carefully before running.
7.
In cold weather or a long time tool not be used, please keep the tool running without load a few
minutes to warm up the grease inside, otherwise hammering function is difficult to get.
8.
Be sure you stand stably and no one is below when you using tool is in high location.
9.
Hold the tool firmly with two hands.
10
. Don't touch any moving parts.
11.
Don't leave the tool running itself, operate tool only when hand-held.
12.
Don't point the tool to anybody for the bit could fly out in case.
13.
Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may
extremely hot and could burn your skin.
14.
Any damage and abnormal happen, please stop to use immediately and disconnect it, ask authorized
serve center to check and repair.
15.
Parts replace:
Only original XINPU's parts can be used to replace by authorized service center.
16.
Right use accessories and parts:
Don't use other parts and accessories which not mentioned in the
manual otherwise may cause injuries!
17.
Special attention to voltage:
Before connect the power tool, please make sure the rated voltage on