XINDAK D2, Инструкция по эксплуатации

Страница: 5 / 8

AAA Batteries
Install Batteries
Before using the remote controller for the first time, you need install
the new battery in the remote controller.
1. Use the tool to remove the rear cover of the remote control unit.
3. Reinstall the rear cover of the remote control unit.
1. Do not use new and old batteries simultaneously.
2. Batteries with similar shapes may have different rated voltage,
be sure to use the correct batteries.
3. Remove batteries from the remote control unit if it will not be used
for a long period of time.
Process
Battery Replacement
2. Install the 2 batteries (AAA) polarity.
1. Use the tool remove the rear cover of the remote control unit.
2. Take out the old batteries from remote control unit.
. Install the 2 batteries (AAA) polarity.
4. Reinstall the rear cover of the remote control unit.
Caution
If you use the remote control unit to control the D10:
1.The remote control range is approximately 5 meters.
2.Pointing the remote control on an angle to the receiver, will
shorten the useful distance of the remote control.
with c/-
3 with c/-
Using Remote Controller
Install Batteries
Battery Reclaim
Please send the waste batteries to local battery
reclaim center. DO NOT discard the waste
batteries discretionarily, in order to avoid
environment pollution.
3
co ax ia l
BA L.
BN C
Vol um e
Introduction
Chapter 3
3.1 Remote Controller
Coa xi al
BAL.
BNC
Volume
Signal input selection buttons