20
Virtex-II Pro ML324 and ML325 Platform
UG063 (v1.2) May 30, 2006
Detailed Description
R
13. Program Switch (Active Low)
The active-low program switch, when pressed, grounds the program pin on the FPGA.
14. Reset Switch (Active Low)
The active-low
reset switch resets the System ACE controller.
15. DONE LED
The DONE LED indicates the status of the
DONE
pin on the FPGA. This LED lights when
DONE
is high or if power is applied to the board without a part in the socket.
16. INIT LED
The INIT LED lights during initialization.
17. Config Address DIP Switch
This switch (SW5) is used to select one of eight addresses in the CompactFlash memory
card, from which a configuration bitstream can be read. The open (“O”) position indicates
a logic ‘0’ and the closed (“C”) position indicates a logic ‘1’ as shown in
.
Table 15:
Bitstream Address Table
2
1
0
Addr
O
O
O
0
O
O
C
1
O
C
O
2
O
C
C
3
C
O
O
4
C
O
C
5
C
C
O
6
C
C
C
7
