Virtex-6 FPGA Connectivity Kit Getting Started
27
UG664 (v1.4) July 6, 2011
Getting Started with the Connectivity Targeted Reference Design Demo
All the drivers required to run the Virtex-6 FPGA Connectivity TRD are successfully
installed. Click
Finish
to exit the Add Hardware Wizard (
Note:
After the drivers are installed,
x_v6_trd_setup.exe
need not be run until the user makes
modifications to the software source code. Running
x_v6_trd_setup.exe
again causes drivers to
uninstall and clean the install folders.
11. Launch the GUI:
a.
Double-click on the
xpmon
icon on the desktop to launch the Performance Monitor
application (
to run the application GUI.
The
xpmon
icon can also be found in the
C:\Program Files\Xilinx
Inc\Virtex6
folder.
Install Linux Driver
12. Configure the desktop PC to boot from the CD ROM:
a.
Power the PC system on and watch the initial BIOS screen for a prompt that
indicates which key to use for either:
X-Ref Target - Figure 18
Figure 18:
All Drivers Installed Successfully
X-Ref Target - Figure 19
Figure 19:
Launch GUI
UG664_66_060
8
11
UG664_67_06
3
011
Содержание Virtex-6 FPGA
Страница 1: ...Virtex 6 FPGA Connectivity Kit Getting Started Guide UG664 v1 4 July 6 2011 XPN 0402826 03...
Страница 4: ...Virtex 6 FPGA Connectivity Kit Getting Started www xilinx com UG664 v1 4 July 6 2011...
Страница 6: ...6 www xilinx com Virtex 6 FPGA Connectivity Kit Getting Started UG664 v1 4 July 6 2011...