36
MicroBlaze Processor Reference Guide
UG081 (v14.7)
Chapter 2:
MicroBlaze Architecture
Process Identifier Register (PID)
The Process Identifier Register is used to uniquely identify a software process during MMU address
translation. It is controlled by the
C_USE_MMU
configuration option on MicroBlaze. The register is
only implemented if
C_USE_MMU
is greater than 1 (User Mode) and
C_AREA_OPTIMIZED
is set
to 0. When accessed with the MFS and MTS instructions, the PID is specified by setting Sa =
0x1000. The register is accessible according to the memory management special registers parameter
C_MMU_TLB_ACCESS
.
PID is also used when accessing a TLB entry:
•
When writing Translation Look-Aside Buffer High (TLBHI) the value of PID is stored in the
TID field of the TLB entry
•
When reading TLBHI and MSR[UM] is not set, the value in the TID field is stored in PID
illustrates the PID register and
provides bit descriptions and reset values.
24
31
↑
↑
RESERVED
PID
Figure 2-12:
PID
Table 2-18:
Process Identifier Register (PID)
Bits
Name
Description
Reset Value
0:23
Reserved
24:31
PID
Used to uniquely identify a software process during
MMU address translation.
Read/Write
0x00
Содержание MicroBlaze
Страница 1: ...MicroBlaze Processor Reference Guide Embedded Development Kit EDK 14 7 UG081 v14 7...
Страница 4: ...MicroBlaze Processor Reference Guide www xilinx com UG081 v14 7...
Страница 8: ...8 www xilinx com MicroBlaze Processor Reference Guide UG081 v14 7 Chapter 1 Introduction Send Feedback...
Страница 262: ...262 www xilinx com MicroBlaze Processor Reference Guide UG081 v14 7 Send Feedback...