General Information
Information from FCC CFR47 Part 15 follows
Section 15.19 Labelling requirements.
(a) In addition to the requirements in part 2 of this chapter, a device subject to certification, or Supplier's
Declaration of Conformity shall be labeled as follows:
(1) Receivers associated with the operation of a licensed radio service, e.g., FM broadcast under
Part 73, land mobile operation under Part 90, etc., shall bear the following statement in a
conspicuous location on the device:
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition
that this device does not cause harmful interference.
(2) A stand-alone cable input selector switch, shall bear the following statement in a conspicuous
location on the device:
This device is verified to comply with Part 15 of the FCC Rules for use with cable television
service.
(3) All other devices shall bear the following statement in a conspicuous location on the device:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
(4) Where a device is constructed in two or more sections connected by wires and marketed
together, the statement specified under paragraph (a) of this section is required to be affixed only
to the main control unit.
(5) When the device is so small or for such use that it is not practicable to place the statement
specified under paragraph (a) of this section on it, the information required by this paragraph shall
be placed in a prominent location in the instruction manual or pamphlet supplied to the user or,
alternatively, shall be placed on the container in which the device is marketed. However, the FCC
identifier or the unique identifier, as appropriate, must be displayed on the device.
(b) Products subject to authorization under a Declaration of Conformity shall be labelled as follows:
(1) The label shall be located in a conspicuous location on the device and shall contain the unique
identification described in Section 2.1074 of this chapter and the following logo:
(i) If the product is authorized based on testing of the product or system; or
