V1.1 04. 25.18
XTouch80
- 8" Touch Panel
User Interface
Quick Install Guide
English
The
XTouch80
has been designed to provide years of trouble free operation when wired and installed properly.
The
XTouch80
has been designed for installation in low humidity indoor environments and should never be
installed outdoors or in high humidity areas.
Included in the box
.
1ea
XTouch80
touch panel
.
1ea
XTouch80
mounting bracket
.
4ea Mounting Screws
Introduction
To install the
XTouch80
, you will also need a standard 2 gang US junction box or low voltage bracket.
4
Important Safety Instructions
1. Read, understand and follow ALL safety and installation instructions included in this manual. Failure to
follow the included documentation may damage the product and will void manufacturer’s warranty.
2. Follow ALL installation guidelines included with the product. Installation of the product in high humidity
environments, in close proximity to heat sources and / or non-recommended locations WILL impede,
interfere and/or damage the intended operation of the product.
3. Only use attachments and accessories which have been specified for use by for use by the manufacturer.
4. The use of abrasive, liquid or solvent based cleaning fluids WILL damage the product.
5. Product Servicing may ONLY be completed by authorized or certified service centers & personnel. For a
complete list of product servicing options, please follow instructions included in the product
documentation and /or contact original manufacturer for details.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
3
Removing the XTouch80
– Using a precision Philips head screw driver to loosen the 2 captive screws on the
XTouch80
, then slightly
pull straight up from the mounting frame to disengage the unit.
2
Powering up the XTouch80
The
XTouch80
will automatically power on when power is applied.
Wait for the unit to boot up.
– When connected to a network switch by Ethernet cable the
XTouch80
will
acquire a network address via DHCP and automatically connect to the system.
Loosen
