Xilica Audio Design NeuPanel Mini K1, Руководство пользователя

Страница: 8 / 29

8
Initial Device Connectivity:
Xilica processors and control devices run on a network based infrastructure and are set up and controlled by
a host computer via Ethernet using the Xilica Designer software.
A network connection can be made between the computer and processor using:
a) DHCP enabled Router or Server/Router combination (Recommended)
b) or a non-DHCP enabled network connection (i.e. PoE switches).
Note: DHCP enabled Router/switch gear should be turned on first, with all Ethernet cables connected to the
hardware prior to powering on the Hardware. This will allow for proper handling of IP address distribution to
the Hardware. The IP address assignment is automatic if connected to a DHCP enabled network.
A) DHCP enabled router or server/router combination (Recommended)
POWER MAINS: 90-240 VAC 50-60Hz, 20VA
FUSE: T2.5A-250V
I
O
Ethernet Control
Designed and Engineered in Canada
IP Reset
G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - +
INPUTS
OUTPUTS
USE ONL
Y WITH 250V FUSE
Power over Ethernet
POWER MAINS: 90-240 VAC 50-60Hz, 20VA
FUSE: T2.5A-250V
I
O
Ethernet Control
Designed and Engineered in Canada
IP Reset
G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - + G - +
INPUTS
OUTPUTS
USE ONL
Y WITH 250V FUSE
Wall Controls
PC or Mac
PC or Mac
B) Non-DHCP direct connection
NeuPanel:Device connection